It didn't come with any instructions so i'm left wondering if i should simply glue the edges (i doubt it would last long that way) or if i need to add extra support to the edges somehow.
Anybody's experience in this area would be appreciated.
best way to assemble the protoparts box?
Tue, 05/31/2005 - 11:56
Tue, 05/31/2005 - 12:10
#1
best way to assemble the protoparts box?
The best method I've found is to simply use packing tape to tape up the outside corners. Make sure you tape the bottom half of the box very tightly and the top half somewhat loosely, otherwise you'll have a heck of a time getting the top off. Use clear tape as it is the best looking until your able to wrap graphics around the box (if you we're planning on doing this, but that's a whole nother process).
-Darke
